NCE 524326 DCC Meter/Analyzer

 DCC Meter/Analyzer
Simple hookup, easy connection to track
 Meter Features:
• DCC volt Meter function measures up to 25 volts DCC
• DCC Amp meter function measures up to 11.5 Amps
Packet Analyzer Features:
• View DCC packets sent by command station on a computer screen
• Selectively filter out idle, reset, accessory, function and or speed packets
• Opto-isolated to prevent ground loops from DCC system to computer
• Powered from track no extra power supply needed
• Display in Hex or Verbose mode
 Additional Requirements:
• PC/Mac/Linux computer
• USB cable

5240326
 5240326

Usage as a DCC Voltmeter and Amp Meter:
Your DCC meter is normally hooked up such that the track power coming from your DCC
system flows through the meter to the track.
Hook up the power coming from your DCC booster to the blue connector that plugs into the left
side of the meter labeled “DCC INPUT”. Next hook up power for the track to the blue connector
that plugs in to the right side of the meter labeled “TO TRACK”
The meter will measure DCC voltages from 7 to 25 volts and Amps from 0 to 11.5 amps.
NOTE: The meter will only begin display volts and amps when hooked to DCC power.
You can also use the meter as a portable DCC voltmeter by installing 2 bent wires into one of
the blue connectors as shown in the photos below (connection to right side not needed) An
extra blue connector is included for this purpose.